CAMCORP SWF with Externally Mounted Fan User Manual
Page 26
SAFETY RECOMMENDATIONS
Because this unit may be under pressure, do not attempt to open any device doors or
panels while fans or blowers are running.
If your unit is equipped with a discharge auger or an airlock, be sure chain guards are
installed before start-up and servicing is attempted only after electrical power is locked
out.
While servicing the filter, it is very important that there are no open flames, welding or
grinding sparks. Dust laden air could be highly explosive and extreme care must be
taken.
Before entering any dust collector:
1.
Run cleaning mechanism 20 minutes with the fan off to clean filter bags.
2.
Discharge solids from hopper.
3.
Lock out electrical power on all rotating equipment.
4.
On toxic operation, purge collector housing and install a blank in the inlet
duct.
5.
Install catwalks and safety cables.
6.
Secure access doors in an open position or remove doors.
7.
Use buddy system.
8.
Wear a respirator.
9.
Use common sense.
11-1
CAMCORP, INC.
Phone: 913-831-0740 Fax: 913-831-9271