Caravell 375-037 - Manual (Page 10)

Commercial cabinets English
10
•
Is the fuse in the meter cabinet intact?
•
Has any fault current relay been disconnected?
• Has there been a complete power failure?
If the cabinet is in a very hot place or air circulation is poor, you
should provide the necessary circulation.
If the condenser is not clean, it should be vacuum-cleaned. If you
have checked the above and the cabinet is still not working, call a
service technician.
State the type of fault and appliance, serial number and item no.
(indicated on the sign inside the cabinet).
If there is condensation on the door on models 366-368:
1 Does the door have power? This can be checked with a
voltmeter on the transformer in the engine room. The voltage must
be 42 Volt AC.
2. If there is power in the door, condensation may be caused by
particularly high air humidity Normal air humidity RF 60%.
3. If power to the door and the air humidity are low, the defect may
be due to lack of connection in the door and the door will then
need to be replaced.
4. If the door has no power, the fuse in the transformer may have
blown. Fuse: Ø5 X 20 mm 4 AMP. Let an authorised electrician or
refrigeration technician replace the fuse.
8 Disposal
The owner of the cabinet is responsible for disposing of the cabinet
in a responsible way in accordance with the relevant legislation.
When a worn-out cabinet is to be disposed of, it should be
disposed of in an environmentally friendly and safe way.
Be aware of the rules for disposal. There may be special
requirements/regulations that need to be complied with.
You can obtain information on disposal from:
•
Your dealer
•
The relevant authorities (municipal authority, Danish
Environmental Protection Agency or other similar body)
•
WEEE marking.
Handling of worn-out electrical and electronic products. Applies to
the European Union and other European countries with separate
collection systems.
9 Special considerations
The information in this user manual was correct at the time of
printing.
Due to our programme of continuous product development, we
must however reserve the right to make technical changes to the
refrigeration/freezer models in this manual. We will of course strive
continually to update the user manual.
You should contact your dealer, who can advise you further, if you
have any doubts concerning the correct use of the freezer.
The manufacturer accepts no liability for accidents or
complications caused by the incorrect connection of the appliance.
10 Guarantee:
Any guarantee will be void if the product has been misused!
This means used for purposes other than those originally intended,
failure to follow the instructions in this manual and transport of the
product not in its original packaging.
If unauthorised personnel make changes to the cabinet, the
manufacturer accepts no liability for material damage and/or
personal injury.
It is in your own interests always to use factory-authorised
personnel for any modification, repair or servicing.
The manufacturer reserves the right to make changes to
specifications without any prior notice or undertaking concerning
the availability of spare parts.