Carl Goldberg GBGA1077 User Manual
Page 19
19
6.
Attach the two pieces of 5mm tubing to the
two tank outlets. Use different colors so you
can tell which is the vent and which is the
fuel pickup after the tank is installed. Make a
note of which color you attach to which tube.
The short brass with the clunk is the fuel
pickup and must go to the carburetor. The
long brass tube is the vent and should go to
the pressure outlet on the muffler.
Set tank aside till ready to install.
3.
Screw the nose gear blocks to the firewall
with the 4-40 x 5/8" screws and the #4
washers. Don’t tighten the bolts until both
blocks are in place and the nose gear is
inserted in the holes. This will hold the
blocks in alignment while you tighten down
the bolts. Be sure to use locktite on the
bolts.
1.
Gather the following items:
(4) 4-40 x 5/8" socket head screw
(4) #4 washer
(1) Nylon nose gear block
(1) Nose Gear Wire
(2) 5mm wheel collar
(1) Nylon steering arm
(1) set screw for steering arm
NOSE GEAR INSTALLATION
2.
Cut the two tabs holding the nose gear
blocks together. The blocks have a shoulder
on one side. The shoulder should go toward
the top on both pieces.
shoulder