Carl Goldberg GBGA1077 - Manual (Page 7)

7
WING ASSEMBLY & INSTALLATION
AILERON and Flap INSTALLATION
1. Collect the following parts:
(1) Left and right wing
(1) Left and right aileron
(1) Left and right flap
(14) CA hinge
2. Locate the pre-cut aileron and flap hinge
slots in both wing halves. Using a hobby knife
(#11 blade), slide the blade into each slot to
make sure it is cleanly cut.
Repeat this process with the ailerons and
flaps, making sure all hinge slots are clean.
3. Place a straight pin into the center of each of
the four CA hinges.
Slide each hinge into the hinge slots on one
of the wing halves. The pin will prevent the
hinges from going in further than halfway into
the wing.
4. Select the aileron for the wing on which you
are working and insert the exposed half of
each hinge into the aileron slots.
Slide the aileron toward the wing until no gap
remains between the aileron and the wing.
Install the flap in the same manner. Align the
stripes on the wing and make sure the
aileron clears the tip and the flap.
5. When satisfied with the alignment, remove
the straight pins, being sure to keep the
aileron and flap tight to the wing. You may
wish to apply a few pieces of masking tape to
keep the pieces in place.
6. Keeping the aileron, flap, and wing in posi-
tion, apply 3 or 4 drops of thin CA to the small
exposed area of each hinge.
Turn the assembly over and again apply 3 or
4 drops of CA to the exposed hinge surfaces.
Allow to dry for 10 minutes before flexing the
aileron.
7. Repeat the above steps for the other half of
the wing and each flap.
AILERON SERVO INSTALLATION
The following pictures may not exactly match the hard-
ware you are using. Always check the radio manufac-
turer's instructions when installing radio equipment.
1. Collect the following items:
(2) Wing halves
(4) Servos with rubber grommets
(16)Servo Mounting Screw (supplied with radio)
(2) 18” servo extensions
(2) 6” servo extensions