Cables to Go AVS815 User Manual
Page 10
6. The infra-red remote-control unit for the cable tuner
28
General
You need the RC 815 remote-control unit in order to be able to control
the cable tuner integrated into the AVS 850 Power Transmitter. The basic
code "0000” is set on the remote-control unit when it is delivered. This
code can be changed, e.g. if two parties in one building want to use the
AVS 815 Power Transmitter in parallel (see more about this under Point
6.4).
Control elements
TX Power:
for switching the 2.4 GHz wireless transmitter on and off
Power:
for switching the AVS 850 on and off
0-9,+100:
direct TV channel selection
CH:
for paging up and down through the cable-TV channels
CH RTN:
for switching back to the channel last selected.
TV/CATV:
for switching between TV channels and cable
TV channels.
TV/VIDEO:
for switching between cable TV and video input
SCAN:
automatic search tuning for TV and cable TV transmitters
(to start the automatic search tuning, press "SCAN” twice)
CH+/-:
Add or delete cable TV channels.
To delete a channel, select the one you want to delete,
such as no. 30, and press "CH+/-”. "-30 CANCEL” will
appear in the screen. Next time you page through the
channel, no. 30 will no longer appear.
To add a channel (again), select it directly, e.g. select no.
30 by pressing 3+0. Press "CH+”. "-30 ADD” will appear
in the display. Next time you page through the channel,
no. 30 will be there.
TXA-TXD:
for setting the 2.4 GHz transmission channel. This setting
must be the same as the channel in the AVS 840 Power
Transmitter. TXA=Channel 1, TXB= Channel 2,
TXC= Channel 3, TXD= Channel 4.
SET:
for setting the code (see Point 6.2).
VOL:
no function
FUNC:
for setting the code (see Point 6.2).
MTS:
no function
MUTE:
no function
RECALL:
shows the current mode in the TV channel and wireless
channel (e.g. TXA) in the television screen.