Cables to Go AVS815 - Manual (Page 18)

9. Rectifying a malfunction
36
Poor transmission quality 1. Reflections of the signal can sometimes affect the transmission
quality. Move the Power Transmitter or Receiver away just a few
inches and this should solve the problem.
2. Change the channel settings (1 to 4) on the Power Transmitter
and the Power Receiver.
No transmission 1. Is the same transmission channel (1 to 4) set on the Power
Transmitter and on the Power Receiver?
2. Is the transmission distance too great? Reduce the distance
between the Power Transmitter and the Power Receiver. The
range is up to 300 metres line-of-sight, but walls and ceilings
reduce it.
3. Have you used the right scart cable?
Remote-control channel 1. If you operate wireless headphones or a similar wireless
transmitter on the same frequency as the AVS 815, this can
severely reduce its range.
2. Is the RX cable inserted into the AVS 850 and glued over the
infra-red eye of the unit that is being controlled?
Problem Remedy
RC 815 infra-red remote-control does not control the AVS 850 1. Wrong code set. Reset the code as described in Point 7.4.