Champion Power Equipment 100133 - Manual (Page 13)

10
100133 ENGLISH
ASSEMBLy
The pump outlet connection does NOT require teflon
tape . The o-ring seals against the face of the fittings on
the pump and hose . Tighten to approximately 12 ft-lb .
Over-tightening can damage the pump .
NOTE
6) Install the Thrust Plate and Cylinder
1 . Slide the thrust plate under the rails on the beam
and push it to the front of the beam to make room
for the cylinder . (A)
2 . Remove the two cylinder retainer plates, M10x25
bolts, M10 washers and M10 lock washers on each
side . (B)
3 . Place the hydraulic cylinder into the mounting slots
on the beam and slide all the way into the slots . (C)
4 . Secure the cylinder by re-installing both cylinder
retainer plates with the M10x25 bolts, M10 washers
and M10 lock washers on each side .
5 . Tighten . Do not over tighten .
6 . Attach thrust plate to cylinder rod with M12x75 bolt
and M12 lock nut . (D)
7 . Tighten . Do not over tighten .
7) Install the Hydraulic Hoses
1 . Place the O-ring into the counterbore in the pump
outlet fitting . (A)
2 . Connect the high pressure hose from the inlet on the
control valve to the pump outlet fitting . (B)
12.5
其余
B
B
A
C
D
B
C
A A
3 . Connect the oil return hose from the beam to the
barbed fittings on the control valve . Secure with hose
clamps . (C)