Operation, Wo rk zo ne, Warning – Champion Power Equipment 100133 User Manual

Page 18: Caution

Advertising
background image

15

ENGLISH

100133

OPERATION

Before Each Use Inspect the Log Splitter

1 . Check the hydraulic oil level and visually inspect all

hoses, attachments and cylinder for loose fittings,
leaks, cracks, fraying or other damage .

2 . DO NOT operate the log splitter if there is any

indication of damage .

3 . Inspect the engine and make sure the oil level is

correct before operating . If the engine is equipped
with a spark arrestor, clean and inspect it regularly
(follow spark arrestor maintenance schedule) .

4 . The tires need to be fully inflated and in good repair .

Reference the tire sidewall for recommended tire
pressure .

Towing Log Splitter Safety

1 . Always check local and state regulations regarding

the requirements for towing, licensing and lights .

2 . Before towing make sure the log splitter is correctly

and securely attached to the vehicle and the safety
chains attached with enough slack to allow for
turning .

3 . Support leg must be pinned in the “UP” position for

towing .

4 . Never exceed the max . travel speed of 45 mph .

Towing the log splitter at speeds greater than 45
mph could result in serious injury or death . Always
adjust your towing speed according to the terrain
and conditions .

5 . Always disconnect the log splitter from the towing

vehicle before operating .

DO NOT over inflate tires . Serious injury can result
if tires explode .
DO NOT tow the log splitter if the tires are worn or
will not hold air .
DO NOT exceed the maximum 45 MPH (72 KPH)
towing speed .

WARNING

Wo

rk

Zo

ne

Log Splitter Location

This log splitter must have at least 7 ft . (2 .1 m) of
clearance from combustible material . Leave at least
3 ft . (91 .4 cm) of clearance on all sides of the log
splitter to allow for adequate cooling, maintenance and
servicing . DO NOT place the log splitter near vents or
intakes where engine exhaust fumes could be drawn into
occupied or confined spaces .

Always operate the log

splitter outdoors.
The log splitter needs to be on a dry level surface with
good footing . DO NOT work on mud, ice, tall grass,
brush or snow .
Only operate log splitter from work zone shown below .

When backing up, use caution . Because of the
short distance between the ball hitch and tires, the
log splitter can turn sharply / abruptly and come in
contact with your towing vehicle

CAUTION

Advertising