Champion Power Equipment 100133 - Manual (Page 17)

14
100133 ENGLISH
ASSEMBLy
When the outdoor tempurature is below 32 ˚F,
Dexron III transmission fluid can be used . Do not
mix hydraulic oil and transmission fluid . Drain all oil
or fulid before adding the other one .
NOTE
To check oil level, use the oil sight glass on the
side of the beam . The oil sight glass has a marker
for the acceptable level of oil . If oil is below the
marker, add oil as needed .
NOTE
Add Hydraulic Oil
1 . Make sure the log splitter is on a flat, level surface .
2 . Remove the R3/4 screw from the reducing elbow
25x20 on the side of the beam . (A) DO NOT remove the R3/4 screw when the engine
is running or hot . Hot oil can escape causing
severe burns . Always allow the log splitter to cool
completely before removing the hydraulic oil screw .
High fluid pressure and temperatures are created
in the hydraulic log splitters . Hydraulic fluid will
escape through a pin-size hole opening and can
puncture skin and cause severe blood poisoning .
Inspect hydraulic system regularly for possible
leaks . Never check for leaks with your hand while
the system is pressurized . Seek medical attention
immediately if injured by escaping fluid .
WARNING
Add Hydraulic Oil Cont’d.
A
B
3 . Using a funnel, add up to 2 .1 gal . (7 .9 L) of
hydraulic oil - 10W AW32, ASLE H-150, or ISO 32 .
4 . Check the hydraulic oil level using oil sight glass on
the side of the beam . (B)
5 . Replace and tighten the R3/4 screw . Do not over
tighten .
6 . Start Engine . Extend and retract the cylinder to
purge air from the hydraulic system . Cylinder motion
should be smooth and continuous .
7 . Check the hydraulic oil tank oil sight glass . Add
additional hydraulic oil if needed . Do not overfill .
8 . Check oil level daily and before each use, and add oil
as needed .