Champion Power Equipment 100133 - Manual (Page 21)

18
100133 ENGLISH
MAINTENANCE AND STORAGE
The owner/operator is responsible for all periodic
maintenance .
Complete all scheduled maintenance in a timely manner .
Correct any issue before operating the log splitter .
For service or parts assistance, contact our help line
at
1-877-338-0999 .
NOTE
Never operate a damaged or defective log splitter .
WARNING
Improper maintenance will void your warranty .
WARNING
Engine Maintenance
To prevent accidental starting, remove and ground spark
plug wire before performing any service .
Oil
Change oil when the engine is warm . Refer to the oil
specifi cation to select the proper grade of oil for your
operating environment .
1 . Remove the oil drain plug with a 12 mm socket and
extension .
2 . Allow the oil to drain completely .
3 . Replace the drain plug .
4 . Remove oil fi ll cap/dipstick to add oil .
5 . Using a funnel, add up to 0 .6 qt . (0 .6 L) of oil and
replace oil fi ll cap/dipstick .
6 . Dispose of used oil at an approved waste
management facility .
Spark Plugs
1 . Remove the spark plug cable from the spark plug .
2 . Inspect the electrode on the plug . It must be clean
and not worn to produce the spark required for
ignition .
3 . Make certain the spark plug gap is 0 .7 - 0 .8 mm
(0 .028 - 0 .031 in .) .
Log Splitter Maintenance
Make certain that the log splitter is kept clean and stored
properly . Only operate the unit on a fl at, level surface in
a clean, dry operating environment . DO NOT expose the
unit to extreme conditions, excessive dust, dirt, moisture
or corrosive vapours .
Inspect all air vents and cooling slots to ensure that they
are clean and unobstructed .
Clean spark arrester every 100 hours (if equipped) .
Check and tighten all bolts and nuts before operating the
log splitter .
Air Filter
1 . Unscrew wing nut to remove the air fi lter cover .
2 . Unscrew wing nut to remove the air fi lter .
3 . Separate the foam element and the paper element .
4 . Tap the paper fi lter element to remove dirt and
debris . Use compressed air (25 PSI) to clear debris .
5 . For the foam element: Wash in liquid detergent and
water . Squeeze thoroughly dry in a clean cloth .
6 . Saturate in clean engine oil .
7 . Squeeze in a clean, absorbent cloth to remove all
excess oil .
8 . Reassemble the two elements and reattach . Tighten
wing nut .
9 . Reattach the air fi lter cover and snap in place .
0.7 - 0.8 mm
0.028 - 0.031 in.
4 . Refer to the spark plug recommendation chart when
replacing the plug .
5 . Carefully thread the plug into the engine .
6 . Use the spark plug tool to fi rmly install the plug .
7 . Attach the spark plug wire to the plug .