CHEVROLET 2012 Camaro - Manual (Page 252)

Black plate (46,1) Chevrolet Camaro Owner Manual (Include Mex) - 2012
9-46 Driving and Operating
These lights are on when the
vehicle is in the PTM Mode.
This optional handling mode can be
selected by pressing the TCS/
StabiliTrak button on the console
quickly two times. The appropriate
message displays in the DIC. See
Ride Control System Messages on
page 5‑40.
To experience the performance
benefit of this system, after entering
a curve and at the point where the
driver would normally start to
increase acceleration, the
accelerator pedal can be fully
pressed. The PTM system will
modify the level of engine power for
a smooth and consistent corner exit.
To select a mode while in PTM,
push the Selective Ride Control/
PTM − TOUR or + SPORT button
on the center console.
The PTM system contains five
modes. These modes are selected
by pressing the Selective Ride
Control/PTM TOUR − or
SPORT + button on the center
console. The driver scrolls up or
down through modes 1–5 by
pressing the TOUR − or
SPORT + button.
The following is a DIC display
description and the recommended
usage of each mode.
PERF TRACTION 1 – WET /
ACTIVE HANDLING ON
. Intended for all driver skill levels.
. Wet or damp conditions
only — not intended for use in
heavy rain or standing water.
. StabiliTrak is on and engine
power is reduced based on
conditions.