Clarity XLC Cordless 3.5HSB - Manual (Page 14)

14
XLC3.5HS/B
Part 15 of FCC Rules
Information
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Your equipment has been tested and
found to comply with the limits of a
Class B digital device, pursuant to
Part 15 of FCC rules. These limits are
designed to provide reasonable
protection against harmful interference
in residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a
particular installation; if this equipment
does cause harmful interference
to radio or television reception,
which can be determined by turning
the equipment off and on, you are
encouraged to try to correct the
interference by one of the following
measures:
1. Where it can be done safely,
reorient the receiving television
or radio antenna.
2. To the extent possible, relocate
the television, radio or other
receiver with respect to the
telephone equipment. (This increases
the separation between the
telephone equipment and the
receiver.)
3. Connect the telephone equipment
into an outlet on a circuit different
from that to which the television,
radio, or other receiver is
connected.
4. Consult the dealer or an
experienced Radio/TV Technician for
help.
Privacy of communications may not be
ensured when using this phone.
WARNING: To maintain the
compliance with the FCC’s RF exposure
guideline, place the base unit at least 20
cm from nearby persons.
For body worn operation, this handset
has been tested and meets the FCC RF
exposure guidelines when used with
the Clarity and Plantronics accessories
supplied or designated for this product.
Use of other accessories may not
ensure compliance with FCC RF
exposure guidlines.
WARNING: Changes or modifications
to this equipment not expressly
approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
Industry Canada Technical
Specifications
This product meets the
applicable Industry Canada
technical specifications.
Before installing this equipment, users
should ensure that it is permissible
to be connected to the facilities of
the local telecommunications company.
The equipment must also be installed
REGULATORY COMPLIANCE