Chicago Faucets Plumbing Product - Manual (Page 8)

8
Geberit Tessera TM Toilet System
Installation & Maintenance Instructions
ACCESS PANEL-FLUSH ACTUATOR INSTALLATION
6
1
3
1. Purge supply line, connect
braided hose to stop valve.
2. Insert refill tube into overflow
funnel and fill tank with water.
3. Flush tank and observe refil-
ling, Tank water level WL must
be 3/4” below over flow level
OFL.
2
1. Remove mud guard cover.
2. Trim off excess material to be flush with wall.
3. Discard cover and excess material.
Lift out cover plate.
4 5
1. Install two (2) threaded lock pins
(part of actuator assembly).
2. Adjust lock pin length to be flush
with finished wall, turn to lock in
place.
1. Reset cover plate
in tank opening
interlock with
two (2) bracket
slots on bottom
2. Snap in place on
top.
1. Adjust fill valve
if needed
(factory set)