Whirlpool Freezer - Manual (Page 27)

Opening and Closing Your Fresh Food Doors
(select models)
Your new refrigerator is uniquely designed with two fresh food
doors. Either door can be opened or closed independently of
one another.
There is a vertically-hinged section on the left fresh food door.
When the left door is closed, the hinged section automatically forms
a seal between the two doors when both doors are closed.
WATER CONNECTION
Disconnect the appliance from the mains power supply
before starting operations.
• The ice maker and water circuit must be connected to a
water supply of potable and/or chemically purified water.
• The water connection must be carried out in compliance with
local regulations.
• The appliance is supplied with a water tube and with a
transition connector for connecting to the water tube and
supply, (some models)
• Remove the protective cap from the end of the gray water
tubing.
• Connect the water tube (I) to the transition connector (2).
Finger tightening and then I to 2 additional turns should be
adequate (for some models connector is placed directly on
water tube).
• Connect the transition connector (2) to the household water
supply (3).
• (4) Remove Plastic cap from water valve inlet port.
• (5) Place end of Plastic tubing into water valve inlet port.
• (6) Slide brass nut over sleeve and screw nut into inlet port.
Tighten nut with wrench. Do not overtighten. Connect tubing
to frame with water tubing clamp (C).
• Make sure that the water tube is not twisted.
• The appliance is pre-set for operation at pressures between
2.4 and 8.3 bar (35 and 120 PSI).
• Open the water tap. Check for and eliminate any leaks.
• The appliance does not require any adjustment or water drain.
218