Whirlpool Thin Twin User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Preform the flex pipe to the left or right. Pull
the flexpipe through the knockout opening
until the clip “snaps” into place.
(Fig. 9)
NOTE: The flex pipe may also be used to
exhaust down or straight out the
back. In these cases, the clip is
not needed.
5. Maintain the position of the dip with one hand
and secure the screw with the other hand. Make
sure the screw is snug against the flex pipe,
but do not break through.
(Fig. 10}
SCREWDRIVER
Fig. 9
6. Tape all of the connections with duct tape, then proceed with the installation.
NOTE: When changing vent directions, use plugs to cover the panel exhaust holes.
692790-White Plug
692791 - Almond Plug