Chariot Carriers Babya Carrier - Manual (Page 14)

13 13
STROLLING CTS KIT ( STROLLING CTS KIT ( wheels only wheels only ) )
2.0 Installation
Push the button located on the side of the
wing as far in as possible. This will create
an opening for the caster shaft.
2.1. Storage
To store the wheels on the carrier when
using another conversion kit, turn the wheel
assembly upside down angled towards the
back of the carrier. While maintaining the
button depressed, slide the wheel down into
the opening, then release the button once
fully inserted. While maintaining the button depressed,
slide the stroller caster from the buttom up
into the carrier’s wing. When fully inserted,
release the button and it should return to its
locked position. To make sure the caster is
secured, test by trying to pull the caster
down.
WARNING:
Overloading the carrier with more than 2.2 lb (1 kg) in the rear storage pouches can make the carrier unstable.
Failure to properly attach wheels could cause the wheels to fall off, resulting in an accident and serious injury.
Direct impacts against the pivoting stroller wheels could cause damage to the wheel arm attachment brackets.
The following safety precautions should be followed, otherwise injury or death to you or to your passengers could result:
– Use wrist safety strap at all times.
– Always use seat belts.
– Always use parking brake when stroller is stationary.
– Never in-line skate with the stroller kit.
– Never climb or descend stairs with the stroller.
– Use extreme caution on hills.