Chariot Carriers Babya Carrier - Manual (Page 17)

Note: the small diameter of the Skewer
Springs should point inward towards the
hub axle.
Position the Hitch QR Lever so it points straight
out from the hub (open position). Tighten the
QR Nut on the opposite end of the Hitch QR
Skewer until finger tight.
Remove your existing QR skewer from your
bicycle rear wheel hub. Remove the QR nut and
one Skewer Spring from the Hitch QR Skewer.
Insert the Hitch QR Skewer making sure that
the cup washer is next to the QR Lever and
the Axle Mounted Hitch Cup is on the outside
of the bicycle frame drop out. Ensure that the
Axle Mounted Hitch Cup is oriented so that the
cup itself is below the Hitch QR Skewer and
the cup opening is facing forward.
4.2 Attaching Your Axle Mounted Hitch
Cup to Your Bicycle if You Have a Solid
Axle Style Hub
Note: The hitch QR skewer will not be
used with a solid axle style hub.
Move the Hitch QR Lever to the closed position.
It should take a noticeable amount of force to
close the lever (it should leave an imprint of
the lever on your palm). The Hitch QR Lever
should always be closed so that the lever
points to the rear of the bike. This will prevent
the Hitch QR Lever from catching and
opening while you are riding.
4.1 Attaching Your New Quick Release (QR) Skewer & Axle Mounted Hitch Cup to Your Bicycle
16 16
4.0 Reflectors and Flag Assembly
Attach the reflector to the spokes.
Insert the orange clip into the reflector and
over the spoke. With a slot screwdriver, turn
the clip until reflector is tight and unable to
shift.
Attach the red reflector to the left grommet
on the rear of the back storage bag.
Insert the flag into hole
located in the plastic cap on the upper left
rear side of frame. Slide the flag down into
hole until flag touches the bottom of the
tube.
Note: For additional visibility you may wish
to purchase a battery powered clip-on light
from your local Chariot retailer. This light
can be connected to the top rear of the
PLASTIC CAP
LOCATION FOR
FLASHING CLIP
ON LIGHT
WARNING: Failure to properly install and
tighten the QR skewer or axle nut could
cause hitch failure and wheel loss
resulting in serious injury or death. Remove the axle nut from your bicycles rear
wheel hub axle ( Note: if there is a washer,
remove and discard it – the Axle Mounted
Hitch Cup will replace it). Install the Axle
Mounted Hitch Cup on the wheel hub axle.
Ensure that the Axle Mounted Hitch Cup is
oriented so that the cup itself is below the
solid Axle Bolt and the cup opening is facing
forward. Reinstall the axle nut and tighten