GE 2-9876 - Manual (Page 28)

IN CASE OF DIFFICULTY
If your Answerer does not work properly, follow the service check list. Also
disconnect the Answerer from phone jack and plug a phone you know to be working
into the same jack. If the phone doesn't work, the problem is with the telephone line.
If it is the telephone line, notify the telephone company for service. If the Answerer
continues to malfunction, please make sure you have followed all the instructions in
this manual to correct the problem. If you cannot correct the problem, you can
RESET the unit by disconnecting telephone line cord and removing the 9 volt battery
and unplugging the POWER SUPPLY CORD from the POWER 9V DC JACK on the
back of the unit. (See "Answerer Reset", page 21.) Wait at least 5 seconds and plug
it back in. This will reset the Answerer. The Answerer will return to the "set-up stage"
deleting all messages, outgoing announcements (OGA's), and clear the time clock.
ANSWERER
PROBLEM SOLUTION
1. Display is blank, no
LED’s on.
• Unit not receiving power, check proper connections (page
9).
• Is outlet working?
2. ANNOUNCE 1/
ANNOUNCE 2
LED's flashing
• No personal OGA's have been recorded (unit will use
default OGA, page 13).
3. Can't hear
messages, beeps,
or time/day.
• Adjust volume
4. Display shows ‘‘Lo.’’ • Battery needs to be replaced or installed.
$. Display shows • Answer mode is turned off (page 10).
6. Display is flashing • Memory full condition (page 21).
7. Time/Day Stamp at
1 : 00 am Monday.
• Time clock needs to be set (page 10).
8 Incoming messages
are incomplete
• Was an extension phone picked up?
• Was 2 minute or 4 minute time exceeded?
• Was STOP button pressed?
• Did memory become full?
28