Cncn – GE 2-9876 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
INSTALLATION
4. Connect the Power Cord
Plug the right angle plug on the power cord
in to the "POWER" jack at the rear of the
unit.
5. Plug In the Power Supply
Plug the power supply into the 110 VAC
power outlet. A power-up tone will be heard
and the MESSAGES display will read "00".
The ANNOUNCE 1 and ANNOUNCE 2 LED's
will flash.
Note: If message display flashes "00" and
"Lo". then the unit does not detect a fresh 9V
battery in place.
0 1 6 1 r A 1
o o
MMMCV
f 4MCM*Cr/
cncn
«rvrv
C
3
I=
3
[H
3
o
o o O
6
o o
omtAm
Advertising