Kenmore ULTRAFILTER 300 625.384720 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
- STEP 5: INSTALL STORAGE TANK,
MAKE REMAINING TUBING CONNECTIONS -
1
.
CONNECT DRAIN TUBING, FAUCET TO
DRAIN ADAPTER: Referring to FIG. 8, run the loose
section of
black 3/8"
tubing from the faucet to the
drain adapter, with a black collet, installed on page
6. Cut this tubing as needed to
route in as straight of
a run as possible, without loops, dips, low spots or
kinks.
Cut the end of the tubing square. Then push
all the way into the fitting. PuU on the tubing to be
sure it's held firmly in the adapter fitting. See pages
13 and 14 for tubing connection instructions.
2. CONNECT TUBING TO WATER SUPPLY; Con
nect the feed (green) tube to the water supply fitting
installed on page 5. Connection to the fitting is as de
scribed in Fig. 11, page 14.
3. Move the storage tank into place next to the RO as
sembly. You can stand the tank upright, or lay it on
side. Apply no more than two wraps of Teflon tape
to the threads on the nipple at the top of the tank.
Hand tighten the other included tubing adapter fit
ting with the yellow collet onto the tank nipple, then
wrench 1/4 turn only. BE CAREFUI. NOT TO
CROSS THREAD.
4.
Run the 3/8"
yellow
tubing to the fitting installed
in step 3. Be sure the end of the tubing is cut square,
and insert all the way into the fitting. Again, puU on
the tubing to be sure it's held firmly in the fitting.