Kenmore 116.25812 - Manual (Page 8)

CANISTER
1. Open the canister hood
2. Check to see that the dust bag is proper­
ly installed. See BAG CHANGING for
instructions.
3. Check to see that the motor safety filter is
properly installed. See MOTOR SAFETY
FILTER CHANGING for instructions
HOOD AND TOOL
STORAGE COVER
it is normal for the canister hood and tool
storage cover to come off when opened fur­
ther than needed. Line up the hinge slots,
Insert the hinges into the slots, and cióse
the hood and tool storage cover to reinstall.
A
CAUHON
Never open canister hood with the tool
storage cover open. This will help to
prevent damage from occurring to the
canister hood and/or tool storage cover.
HOSE
1. Line up the hose
latch tab and notch
in canister hood
and insert hose
into canister until it
snaps in place-
To remove: Lift
hose iatch tab
upward and pul! up
on hose.
Handt&
Hose
Latch
Tab
Notch
Lock
Button
Handte
Quick
i?eteas©x,
2, Insert handle
into wand until
lock button
snaps in place,
Be sure hose
is not twisted.
To remove:
Press handle
quick release
button and puli
up on handle,
To store: Disconnect hose from wands and
canister to prevent stress on hose during
storage. Store hose in a loosely coiled
position so the hose covering is not
stressed.
POWER-MATE JR.® STORAGE
This canister is equipped with an on-board
storage area for a Power-Mate Jr. ®
attarhmpnt
(iri ItCA Wt I r I lO I 11 -
To Install:
Open the Power-Mate Jr.® storage cover.
Insert the Power-Mate Jr®, press down into
place, and close the lid securely,
To Remove:
Open the storage cover. Remove Power­
Mate Jr.® from the storage area and use as
needed (see ATTACHMENTS and
attachment use TABLE).
Powar-Mata
Storage Cover