Kenmore 362.6278 - Manual (Page 21)

INSTALLATION OF THE RANGE
INSTALL THE RANGE
8. Replace the Wire Cover
Replace the wire cover on the range back by sliding its
right edge under the retaining tab and replacing the two
screws removed earlier. Make sure that no wires are
pinched between the cover and the range back.
9. Anti-Tip Device Installation
An Anti-Tip bracket is supplied with instructions for
installation in a variety of locations. The instructions
include all necessary information to complete the
installation. Read the Safety Instructions and the
instructions that fit your situation before beginning
installation.
Tj^lcai insiaflation of anti-Hp brackel attachment to wait
A WARNING:
• Range must be secured by Anti-Tip bracket supplied
• If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip device
WB2X7909. Call 1-800-4-MY-HOME®,
• See instructions to instai! (supplied with bracket).
• Unless properly installed, the range could be tipped by
stepping or sitting on the door. Injury may result from
spilled hot liquids or from the range itself,.
10. Level the Range
a. Install the oven shelves in the oven and position the range
where it will be installed
b. Check for levelness by placing a
spirit level or a cup, partially filled
with water, on one of the oven
shelves. If using a spirit level,
take two readings—with the level
placed diagonally first in one
direction and then the other.
c. Remove the storage drawer, broiler drawer or kick
panel. The front leveling legs can be adjusted from the
bottom and the rear legs can be adjusted from the top or
the bottom.
Front leveling legs
(on some models)
d. Use an open-end or adjustable wrench to adjust the
leveling legs until the range is level.
e. Replace the drawer or panel.
21