Reinstalling the refrigerator door, Left door, A caution – Kenmore TRIO 795.785 User Manual
Page 12: Caution, Refrigerator installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REFRIGERATOR INSTALLATION
Reinstalling the Refrigerator Door
► Right Door
1. Lower the door onto middle hinge pin (8).
2. Fit top hinge (5) over hinge lever latch (6) and into place. Insert hinge lever {4) under lever latch. Rotate lever
counterclockwise to secure hinge.
3. Connect wire harnesses (3).
4. Hook tab on door switch side of cover under edge of wire opening in cabinet top. Position cover (2) into place. Insert
and tighten cover screw (1).
► Left Door
1. Lower the door onto middle hinge pin (9).
2. Fit top hinge (7) over hinge lever latch (8) and into place. Insert hinge lever (6) under lever latch. Rotate lever clockwise
to secure hinge.
3. Install the grounding screw (5) and connect the three wire harnesses (4).
4. Push the water supply tube into the hole on the top case and pull it out on the backplate.
5. Insert the water supply tube (3) into the connector tube until you see only one scale mark.
(Fully insert the tube over 5/8”(15mm)).
6. Hook tab on door switch side of cover (2) under edge of wire opening in cabinef fop. Position cover into place. Insert
and tighten cover screw (1).
A
CAUTION
Insert Line
V.
After inserting, pull the tube to
ascertain that it is secure and
assemble the clip.
_y