How to remove and install the pullout drawer, Removing pullout drawer, Refrigerator installation – Kenmore TRIO 795.785 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REFRIGERATOR INSTALLATION
HOW TO REMOVE AND INSTALL THE
PULLOUT DRAWER
IMPORTANT: To avoid possible injury or product or
property damage, you will need two people to perform the
following insfructions.
1. Removing Pullout Drawer
* Pull fhe drawer open to full extension. Remove the
lower basket (1) by lifting basket from rail system.
(If you tilt the door, it will be easier.)
' With both hands, hold both sides of the door and pull it
up to separate it from the rails.
Press both hangers with your thumbs to lift it up.
Separate the left and right rail cover.
Remove the screws(2) of the rail on both sides.
A CAUTION: When you remove the drawer, do not hold
the handle. If it may come off and if could cause
personal injury.
• With both hands hold the center bar and push it in to
allow both rails to slide in simultaneously.
A CAUTION: When laying the drawer down, be careful
not to damage the floor or hurt your feet by the sharp
edges on hinge side.
13