Needle drop, To check, Adjustment procedure – Kenmore 385.15358 User Manual
Page 17: Mechanical adjustment
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
SEWING
machíne
DIV. 20
MODEL 384. 15358
MECHANICAL ADJUSTMENT
NEEDLE DROP
TO CHECK:
WHEN
THE NEEDLE SWINGS IN MAXIMUM ZIGZAG WIDTH, THE DISTANCE BETWEEN
BOTH ENDS OF THE NEEDLE HOLE IN THE NEEDLE PLATE AND THE NEEDLE DROP
POSITIONS SHOULD BE EQUAL.
IF NOT, ADJUST AS FOLLOWS:
ADJUSTMENT PROCEDURE:
1.
REMOVE THE FACE COVER (SEE PAGE 7).
2.
SET THE PATTERN SELECTOR DIAL AT MAXIMUM ZIGZAG WIDTH.
3.
LOOSEN THE SETSCREW.
4.
TURN THE ECCENTRIC PIN TO ADJUST THE NEEDLE DROP.
5.
TIGHTEN THE SETSCREW.
6.
ATTACH THE FACE COVER.
NOTE:
CHECK THE HOOK TIMING AFTER THIS ADJUSTMENT.
ECCENTRIC PIN
BOTH CLEARANCES SHOULD BE EQUAL
15
Advertising