To check, Adjustment procedure, Mechanical adjustment – Kenmore 385.15358 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
SEWING
machíne
DIV. 20
MODEL 384. 15358
MOTOR BELT TENSION
TO CHECK:
1. IMPROPER BELT TENSION MAY CAUSE NOISE, OVERLOAD OF MOTOR, SLOW
RUNNING OR MOTOR BELT JUMPING.
2. THE BELT DEFLECTION SHOULD BE 7 M M - 9 MM WHEN PRESSING THE MIDDLE
OF THE MOTOR BELT WITH APPROXIMATELY 300 GRAMS OF PRESSURE.
ADJUSTMENT PROCEDURE:
1. REMOVE THE BELT COVER (SEE PAGE 7).
2.
LOOSEN THE SCREWS (A) AND (B).
3.
MOVE THE MOTOR UP OR DOWN TO ADJUST THE DEFLECTION ABOUT 7 MM -9
MM.
4. TIGHTEN THE SCREWS (A) AND (B).
5. ATTACH THE BELT COVER.
MECHANICAL ADJUSTMENT
26
Advertising