Kenmore 141.16223 - Manual (Page 4)

CAUTION: BEWARE OF FLASHBACK
CAUTION: Spiders and small insects occa­
sionally spin webs or make nests in the grill
Burner Tubes during transit and warehousing.
These webs can lead to a gas flow obstruc­
tion which could result in a fire in and around
the Burner Tubes. This type of fire is known
as a "FLASHBACK" and can cause serious
damage to your grill and create an unsafe
operating condition for the user.
To reduce the chance of "FLASHBACK", you
must clean the burner tubes before assem­
bling your grill, and at least once a month in
late summer or early fall when spiders are
most active. Also perform this Burner Tube
cleaning procedure if your grill has not been
used for an extended period of time.
Figure 1
Flashback Prevention
To reduce the chance of "FLASHBACK" (see
CAUTION at left) clean the Burner Tubes and
Burners before fully assembling your grill.
Remove the Cotter Pin from the rear underside
of each Burner using a pair of long nose pliers.
Carefully lift each Burner up and away from the
Gas Valve Orifice, then refer to Figure 1 and
perform one of these three cleaning methods:
1
. Bend a stiff wire, (a lightweight coat hanger
works well) into a small hook as shown
below. Run the hook through the Burner Tube
and inside the Burner several times to remove
any debris.
2
.
3.
Use a bottle brush with a flexible handle.
Run the brush through the Burner Tube and
inside the Burner several times, removing any
debris.
Use an air hose to force air through each
Burner Tube. The forced air should pass
debris or obstructions through the Burner and
out the Ports.
GAS COLLECTOR BOX
BURNER TUSE
Assembly Tips
Long nose pliers can be used to remove
Cotter Pin when cleaning the Burners
Use work gloves to protect your hands
Wear eye protection
When you have finished assembiing your
griil we strongiy urge that ali Pattern
Head Thumb Screws be tightened, either
with the suppiied Tightening Tool or a
#2 Philiips Head Screwdriver
Tightening Tool
Ref. # P05515102K
A warning
The location of the Burner Tube with re­
spect to the Orifice is vital for safe
operation. Check to ensure the Orifice is
inside the Burner Tube before using your
gas griil. See Fig. 2. If the Orifice is not
inside the Burner Tube, lighting the Burner
may cause explosion and/or fire.
Figure 2