Setting warmer drawer controls, To operate the warmer {warm & ready™) drawer – Kenmore 790.9446 User Manual

Page 29

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Setting Warmer Drawer Controls

Arranging Warmer Drawer Racks

Operating the Warmer Drawer

Arranging Warmer Drawer {Warm & Ready™ Drawer) Rack Positions (some models)

Note: Use the warmer drawer to keep hot foods hot such as: vegetables, gravies, meats, casseroles, biscuits and rolls,

pastries and heated dinner plates.

The rack can be used in 2 ways:

In the

upright position to allow low profile food items to be placed both under and on top of the rack (for example, rolls

or biscuits on top of the rack and a casserole dish under - See Fig. 1}.

In the

downward position to allow you to place light weight food items and empty dishware (for example, rolls or

pastries and dinner plates - See Fig. 2).

The warmer drawer is equipped with a catch which may require extra force when opening and closing the drawer.

To Operate the Warmer {Warm &

Ready™) Drawer

Always start with hot food. It is not recommended to

heat cold food in the warmer drawer.

All food placed in the warmer drawer should be
covered with a lid or aluminum foil to maintain
quality.

Do not use plastic wrap to cover food.

Plastic may melt onto the drawer and be very

difficult to clean.

Use only dishes, utensils and cookware

recommended for oven use in the warmer drawer.

^CAUTION

Always use pot holders or oven mitts

when removing food from the warmer drawer as
cookware and plates will be HOT.

„WARMER DRAWER

Fig. 3

Warmer Drawer Recommended

Food Settings Table

Food Item

Setting

Bacon

HI

Hamburger Patties

HI

Poultry

HI

Pork Chops

HI

Fried Foods

HI

Pizza

HI

Gravies

MED

Casseroles

MED

Eggs

MED

Roasts (Beef, Pork, Lamb)

MED

Vegetables

MED

Biscuits

MED

Rolls, hard

MED

Pastries

MED

Rolls (soft)

LO

Empty Dinner Plates

LO

rrî

2

To Set the Warmer {Warm & Ready™) Drawer Thermostat
Control (some models)

The thermostat control is used to select the temperature of the warmer drawer.

It is located on the control panel (See Fig. 3). To set the thermostat, push in

and turn the knob to the desired setting. The temperatures are approximate,
and are designated by HI, MED and LO.

1. Turn the knob to select the desired temperature setting.

2.

For best results, preheat the drawer before adding food. An empty drawer

will preheat in approximately 15 minutes.

3. Turn the thermostat control to

OFF after use.

Warmer (Warm & Ready™) Drawer Temperature Selection

(some models)

Refer to the table in the side column for recommended settings. If a particular

food is not listed, start with the medium setting. If more crispness is desired,

remove the lid or aluminum foil.

Most foods can be kept at serving temperatures by using the medium setting.

When a combination of foods are to be kept warm (for instance, a meat with 2
vegetables and rolls), use the high setting.

Refrain from opening the warmer drawer while in use to eliminate loss of heat

from the drawer.

29

Advertising