Kenmore 790. 3017 - Manual (Page 6)

Grounding Instructions
(electric ignjtion models only)
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS.
ik WARNING This appliance is equipped with a 3-prong grounding plug for
your protection against shock hazard and should be plugged directly into a
properly grounded receptacle. DO NOT cutorremovethegroundingprongfrom
this plug.
For personal safety, this oven must be properly grounded. For maximum
safety, the power cord must be plugged into a 120V—60 Hz. outlet that is
correctly polarized and properly grounded.
If a two-prong wall receptacle is the only available outlet, it is the personal
responsibility of the consumer to have it replaced with a properly grounded
three-prong wall receptacle installed by a qualified electrician.
Do not under any circumstances cut or remove the third round grounding
prong from the powercord plug. See the installation instructions packaged with
this oven for complete installation and grounding instructions. Do not operate
the oven using a two-prong adapter or an extension cord.
A WARNING Avoid fire hazard or
electrical shock. Do not use an adaptor
plug, an extension cord, or remove
grounding prong from electrical powercord.
Failure to follow this warning can cause
serious injury, fire or death.
Grounding
type wall
receptacle
Do not, under any
circumstances, cut,
remove, or bypass
the grounding prong.
Power supply cord with
3-prong grounding plug
Owen Ignition
When you turn the oven on, the glow bar igniter begins to heat. When the lighter is hot enough, in less than 1 minute, the gas
flows into the burner and is ignited.
The igniter glows bright orange when hot. It cycles on and off with the thermostat and will glow whenever the burner is on.
A WARNING I Do not attempt to light the oven burners during a power failure. The oven burner valves will not open up
and will prevent the gas from flowing through the burner valves to the burners. In the event of a power failure, turn the
Temperature Control knob to OFF. When power resumes, turn the Temperature Control knob back to desired temperature.
Liquefied Petroleum (Propane) Gas Conversion
This appliance can be used with Natural Gas or Liquefied Petroleum (Propane) Gas. It is shipped from the factory for use with
Natural Gas.
Referto the Installation Instructions for conversion from Natural Gas to Propane Gas, or from Propane Gas to Natural Gas.
A WARNING Severe shock or damage to the appliance may occur if the appliance is not installed by a qualified installer.
A
CAUTION ¡Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application
needs must be made by an authorized Sears Service Center or other qualified L.P. service agency.