Oven vent and racks, Air clrcylation in the oven – Kenmore 790. 3017 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Oven Vent and Racks
Oven Vent Location
A CAUTION
____________j Some models are equipped with a blower which runs in baking
and self-cleaning mode to keep all internal components at a cool temperature.
The blower may keep running even if the oven has been turned off, until the
components have cooled down.
Oven Vent Location
The oven is vented through the upper control panel trim. When the oven is on, warm
air is released through the vent. This venting is necessary for proper air circulation in the
oven and good baking results.
Arranging Oven Racks
ALyS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO
OPERATING THE OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and
slide out.
To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front
of the rack upward and slide the rack back into place.
Air Clrcylation in the Oven
If using 1 rack, place in center of oven. If using multiple racks, stagger cookware
as shown.
For best air circulation and baking results allow 2-4" (5-10 cm) around the
cookware for proper air circulation and be sure pansand cookware do not touch
each other, the oven door, sides or back of the oven cavity. The hot air must
ci rculate around the pans and cookware in the oven for even heat to reach around
the food.