Kenmore 625.34846 - Manual (Page 10)

SECTION 2
HOW YOUR WATER SOFTENER WORKS
2A. FACE PLATE TIMER FEATURES
E)CTRA RECHARGE
Sometimes, a manually started regeneration
(recharge) may be desired, or needed. Two
examples are...
...You have used more water than usual (guests
visiting) and you may run out of soft water before
the next timer started regeneration.
.. .You did not refill the softener with salt before It
was gone.
You can start a regeneration right away, or you
can set the timer to regenerate at the next 2:00
AM (or other preset recharge time). Do the
following.
RECHARGE NOW
■ Press the ON/OFF-HOLD button and hold
for 3 seconds. The softener
enters the fill cycle of regen­
eration right away.. .the dis­
play shows “FillinG NOW”.
This regeneration will last for
about 40 minutes. Then, you
will have soft water again.
RECHARGE TONIGHT
■ Press and release (DO NOT HOLD) the
ON/OFF-HOLD button. RE­
CHARGE TONIGHT flashes
in the display, and the soften­
er begins regeneration at the
next preset recharge time. Press and release
the ON/OFF-HOLD button once more if you
decide to cancel the regeneration, and RE­
CHARGE TONIGHT.
Ft III
nS
MOW
3* 15'
PROGRAM MEMORY
If electrical power to the softener goes off, the
time display is blank but the face plate timer
keeps the correct time for about 6 hours. When
electrical power comes on again, you have to
reset the present time
only if the display is
flashing. The HARDNESS and RECHARGE
TIME never require resetting unless a change is
desired.
Even if the timer is incorrect after a long power
outage, the softener works as it should to keep
you water soft However, regenerations may
occur at the wrong time of day until you reset the
timer to the correct time of day.
ERROR CODE
An error code could appear in the face plate
display if a problem occurs in the softener
electronics. If you see an error
code instead of the present time
of day, please call you local
Sears Service Department for
service.
SOFTENER STATUS DISPLAY
1. SERVICE ( PROVIDING SOFT
WATER) POSITION: The display
shows the present time of day. If
“TURBINE” is flashing, soft water
is currently in use.
2. RECHARGE POSITIONS:
A. Rll Cycle - FillinG NOW shows
in the display. If soft water is being
used, TURBINE" flashes.
B. BRINING. BACKWASH AND
FAST RINSE CYCLES - The dis­
play shows the minutes of recharge
remaining before return to soft wa­
ter service. RECHARGE NOW is
also flashing.
Err
n
u
BP
u
i
tm
Ft 1
11 nS
MOW
10