Sanitizing the water softener – Kenmore 625.34846 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 1
WATER SOFTENER START-UP
1D.
SANITIZING THE WATER SOFTENER
Care is taken at the factory to keep your water
softener clean and sanità^. Materials used to
make the softener will not infect or contaminate
your water supply, and will not c^se bacteria to
form or grow. However, during shipping, storage,
installing and operating, bacteria could get into
the softener. For this reason, sanitizing as
follows Is suggested^ when installing.
1. Lift the salt hole cover and use a pail or hose
to fill the salt storage tank with at least 1
gallon of water.
2.
Remove the brinewell cover {FIG. 2) and
pour about 3/4 ounce of cximmon 5.25%
household bleach (Clorox, Unco, BoPeep,
White
Sail,
Eagle,
etc.)
in
the
softener
brinewell.
3.
Press the ON/OFF-HOLD button and hold for
3 seconds to start a recharge. This first
recharge does several things.
— It draws the bleach into and through the
softener to sanitize it.
— It fills the salt tank to the water level
needed.
— It gets all the air out of the resin tank.
— It makes die resin bed (see page 11}
ready for service.
NOTE:
This recharge takes about 40 minutes.
FIG. 2
ADD WATER
Recommended by the Water Quality Association. On
some water supplies, the water softener may need pe
riodic di^nfecting. Sanitize wi№ or without salt in the
storage tank.
8