Nozzle care, Belt and agitator changing, Nozzle care belt and agitator changing a warning – Kenmore ASPIRADORA 116.31591 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOZZLE CARE
BELT AND AGITATOR CHANGING
A WARNING
Always unplug power cord from
electrical outlet before performing any
service on vacuum cleaner.
1. Turn off and unplug vacuum cleaner.
2. With vacuum cleaner upside down,
remove four (4) screws.
I
3. Remove nozzle
cover by placing
vacuum in upright
position. Grasp rear
of cover and
rotate forward.
Pull up to
release.
Tabs
4. Remove agitator by carefully lifting
out.
5. Remove and replace worn or broken
belt. (Refer to
Replacement Parts
on page 5.)
6. Loop new belt
around motor
shaft and
agitator belt
groove.
7. Reinstall
agitator back
into nozzle by
pulling toward
front of
nozzle and
sliding into
grooves.
8.
After reinstalling agitator, turn it by
hand to make sure that belt is not twisted
or pinched and that all rotating parts turn
freely.
9. Replace cover
by sliding 3 tabs
into place and
rotating closed.
Tabs
-
22
-