Kenmore 911.92485 - Manual (Page 3)

Кептогё:
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE mSTBUCTIONS
Bead ail instructions before using this appliance. When using
gas or electrica! appliances, basic safety precautions should
be followed, including the followings
StmiOTY device
A
WARNING
All Ranges Can Tip
Injury To Persons
Could Result
install Anti-tip
Device Packed With
Range
See installation
instructions
Tools you will need:
* Phillips head screwdriver
e 13/8" open end or adjustable wrench
1. Remove the bracket from the
prepack located inside the oven,
2. Decide whether the bracket will be
installed on the right or left side of
range location ,
3. If the bracket side of the range is
adjacent to a cabinet, place the
bracket against back wall and
cabinet as shown in Figure 1,
If there is no adjacent cabinet,
determine where the location of
the range side (painted outside
panel) will be. Place the bracket
with its outside edge at this
location and against back wall.
See Figure
4. Determine whether you wiii anchor
the bracket to the floor or wall,
Make sure this location is clear of
eiectrical wiring or plumbing
5. Fasten the bracket securely with
the screws provided. Screws are
self-drilling in wood, plywood,
particle and chip board, and most
metal framing, if attaching to
masonry, you can buy suitable
screws and anchors at hardware
stores Use a masonry drill to drill
the required holes
Bracket
Screw Must Enter \
Wood Or Metal ^
Fig, 2
Wall
Plate
/
Attachment To Wall
6, Using the wrench, back out the
four ieg leveiers at least two turns.
See your instaliation guide for
гроге leveling information before
positioning range-
7. Slide the range into place. Be sure
rear leg ieveler fuliy engages the
slot in the bracket. If range cannot
be moved back far enough for
rear leg Ieveler to enter bracket,
move bracket forward as required
and attach to floor in new location.