Before you cali – Kenmore 790.4662 User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before You Cali
Solutions
to Common Problems
Before you call for service,
review this list. It may save you time and expense. The list includes common occurrences
that are not the result of defective workmanship or materials in this appliance.
OCCURRENCE
POSSIBLE CAUSE/SOLUTION
Range is not level.
Poor installation. Place oven rack in center of oven. Place a level on the oven rack.
Adjust leveling legs at base of range until the rack is level. When range Is level, cooktop
may appear out of alignment if countertop is not level.
Weak, unstable floor. Be sure floor Is level and can adequately support range. Contact a
carpenter to correct sagging or sloping floor.
Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets are
square and have sufficient room for range clearance.
Cabinets not square or are built in too tight. Contact a cabinet maker to correct the problem.
Contact builderor installer to make appliance accessible.
Carpeting interferes with range. Provide sufficient space so range can be lifted over carpet.
Gas line is hard-plumbed. Have a flexible C.S.A international approved metal appliance
connectorinstalled.
Make sure cord/plug is tightly into outlet.
Service wiring is not complete. Call 1-800-4-MY-HOME® (See back cover).
Power outage. Check house lights to be sure. Call your local electric company for
service. Surface burners can be lit manually.
Surface burners do not
Surface control knob has not been completely turned to LITE. Push in and turn the
light.
surface control knob to LITE (until burner ignites) and then turn the surface control knob
to the desired flame size.
Burner ports are clogged. Clean burners. See “Cleaning the Burner Grates, Burner Caps
and Burner Heads” underGeneral Cleaning.
Electrical poweroutage.
Be sure the gas supply to the range is turned “ON”.
Cannot move appliance
easily.
Appliance must
be accessible for
service.
Entire range or oven
does not operate.
Surface burnerflame
burns half way around.
Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire or
needle.
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until
flame is full. Dry the burners thoroughly following instructions in the "General Care &
Cleaning" section.
Surface burner flame is Dust particles in main line. Allow the burner to operate a few minutes until flame turns
orange.
blue.
Salt air in coastal areas. A slightly orange flame is unavoidable.
Scratches or abrasions
on cooktop surface.
Coarse particles such as salt or sand between cooktop and utensils can cause scratches.
Be sure cooktop surface and bottoms of utensils are clean before usage. Small scratches
do not affect cooking and will become less visible with time.
Cleaning materials not recommended for ceramic-glass cooktop have been used. See
“Ceramic Glass Cooktop Cleaning & Maintenance” section under General Care & Cleaning.
Cookware with rough bottom has been used. Use smooth, flat-bottomed cookware.
Metalmarks.
Sliding or scraping of metal utensils on cooktop surface. Do not slide metal utensils on
cooktop surface. Use a ceramic-glass cooktop cleaning cream to remove the marks. See
“Ceramic Glass Cooktop Cleaning & Maintenance” section underGeneral Care &
Cleaning.
Brown streaks or specks.
Boilovers are cooked onto surface. Use razor blade scraper to remove soil. See “Ceramic Glass
Cooktop Cleaning & Maintenance” section underGeneral Care & Cleaning.
42