Kenmore 790.4662 - Manual (Page 8)

Assembly of the Surface Burner Heads, Burner Caps and Burner Grates
It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates
are installed correctly and at the correct locations.
1. Be sure to follow the Installation Instructions before
installing and using your new range.
2. Remove all packing tape from cooktop. Remove Burner
Caps and Burner Heads (See Figure 1).
3. Discard all packing material located under all Burner
Heads (if applicable).
4. To replace Burner Heads & Caps, match the letters
located under center of Burner Caps with the letters
located inside Burner Head (only positions A & F are
marked with letters - See Figure 2). Place all Burner
Heads & Caps on the cooktop (See Figure 1) while
carefully aligning the Electrodes into slots or holes of the
Burner Heads (Figure 4). Note: The Burner Heads should
sit flat on Cooktop Burner Skirts.
5. Replace Bridge Burner Caps. These include one Bridge
Burner Center Cap (rectangular shaped) and the two
Bridge Burner End Caps (The Bridge Burner End Caps
will fit either the front or rear Bridge Burner Head loca­
tions). Make sure that the tabs located under the Bridge
Burner Caps fall into the slots located in the Bridge
Burner Head (See arrows in Figure 3) and that all the
Bridge Burner Caps lie flat and evenly on the Bridge
Burner Head.
6. Unpack Burner Grates. NOTE: Do not force End Burner
Grates down on cooktop. Be careful to line up the 2 Grate
Pins located on each of the 2 End Burner Grates into the
Pilot holes located on top of the Burner Caps (See Figure
5). Position Burner Grates on cooktop and check that all
the Burner Grate legs lie on the glass surface.
7. Place Center Burner Grate between the end Burner
Grates.
Before Setting Surface Controls
REMEMBER — DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL TO
ENTER THE GAS ORIFICE HOLDER OPENING. Always
keep the Burner Caps and Burner Heads in place whenever
the surface burners are in use.
Locations of the Gas Surface Burners (See
Figure 6)
The SIMMER burner is best used for simmering delicate
sauces, etc. This burner is located at the right rear burner
position on the cooktop.
The STANDARD sized burner are used for most surface
cooking needs. These burners are located at the left front
and left rear positions on the cooktop.
The POWER burner is best used for bringing large
quantities of liquid rapidly up to temperature or when
preparing larger quantities of food. This burner is located at
the right front position on the cooktop.
The BRIDGE burner is best suited when using rectangular
or long shaped cookware. The left rear and left middle are
combined and controlled by the same control knob. The left
front burner may also be added for a total of 3 burners.
Figure 5
, ,
Figure 6