Kenmore 665.1649 - Manual (Page 9)

The top rack is designed for cups, glasses, and smaller items.
Many items, up to 11 in. (28 cm), fit in the top rack. (See
recommended loading patterns shown.)
NOTE: The features on your dishwasher rack may vary from the
drawings shown.
l-
5l
^ 1
Jti
12 place setting
Ш Place items so open ends face down for cleaning and
draining.
■ Load glasses in top rack only. The bottom rack is not
designed for glasses. Damage can occur.
■ Place cups and glasses in the rows between tines. Placing
them over the tines can lead to breakage and water spots.
■ China, crystal, and other delicate items must not touch each
other during dishwasher operation. Damage may occur.
■ Load lightweight plastic items in the top rack only. Only
plastic items marked “dishwasher safe” are recommended.
■ Load plastic items so the force of the spray does not move
them during the cycle.
■ To avoid chipping, do not let stemware touch other items.
■ Small bowls, pans, and other utensils can be placed in the
top rack. Load bowls in the center section for best stability.
Utensil basket
Use this extra capacity basket in the back of the top rack to hoid
spatulas, wooden spoons, and similar items.
llJiLXll- '■ ’ll -IL
Cup shelves
Fold down the extra shelf on the left-hand or right-hand side of
the top rack to hold additional cups, stemware or long items such
as utensils and spatulas.
NOTE: The features on your dishwasher may vary from those
shown below.
FleMble tines
The row of tines on the left-hand and right-hand sides of the top
rack can be adjusted to make room for a variety of dishes.
To adjust the flexible tines
1 . Grasp the tip of the tine that is in the tine holder.
2. Gently push the tine out of the holder.
3. Lay the tines down, toward the center of the rack.
Adjustable 2-position top rack
You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Raise the top rack to accommodate items up to
9 in. (22 cm) in the top rack and 13 in. (33 cm) in the bottom rack,
or lower the top rack to accommodate items up to
11 in. (28 cm)
in both the top and bottom racks. Adjusters are located on each
side of the top rack.
To raise the top rack
Lift the rack on both sides until the rack is level.
NOTE: The top rack MUST be level.
To lower the top rack
Depress both tabs on rack adjusters, as shown above, and slide
the rack back to its original position.