Surface cooking, After each use, The griddle is dishwasher safe – Kenmore 790.7889 User Manual
Page 11: Using the griddle (some models), To set the cooktop lockout feature (some models), To turn the cooktop lockout feature on, To turn the cooktop lockout feature off
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Surface Cooking
Care of the Griddle
Before first use:
• Wash Griddle in hot soapy water. Rinse and then dry
completely.
After each use:
• Store in a dry place.
• After each use, clean with hot soapy water.
• THE GRIDDLE IS DISHWASHER SAFE.
• Dry Immediately before storing.
Using the Griddle (some models):
• Piace the griddle centered over the Bridge Burner
(some models). For location refer to Fig. 1.
• Preheat the griddle for 5 minutes on medium to
medium low setting. Slow preheat ensures even
heat distribution during the cooking process.
• DO NOT preheat the griddle on HI setting. Preheat
ing on HI may warp the griddle and prevent even
heat distribution.
To Set the Cooktop Lockout Feature
(some models)
A
m
Fig. 1
The pad is used to activate the Cooktop Lockout feature which will lock all gas surface burners from being operated.
This feature will only lock the gas burners on the cooktop.
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL GAS SURFACE BURNER CONTROLS ARE SET TO THE OFF POSITION.
2. Press & hold until one beep is heard (after 3 seconds). The Cooktop Locked indicator iight will turn ON and the gas
surface burners and functions are iocked out until the cooktop is unlocked.
To turn the Cooktop Lockout Feature OFF:
1. BE SURE ALL GAS SURFACE BURNER CONTROLS ARE SET TO THE OFF POSITION.
2. Press & hold until one beep is heard (after 3 seconds). The Cooktop Locked indicator iight will turn OFF and the
gas surface burners may be used normally.
WARNING
I
TURN ALL GAS SURFACE CONTROL KNOBS TO OFF POSITION BEFORE UNLOCKING THE
COOKTOP — To avoid a potential gas flow or fire be sure that ALL gas surface control knobs are set to the OFF position
before unlocking or iocking the cooktop.
IMPORTANT NOTE: Starting a Self-Clean cycle will automatically turn the Cooktop Lockout feature ON. The
cooktop will remain locked after the Self-Clean cycle. Once the Self-Cleaning cycle has completed and the Door
Locked Indicator Light has turned OFF, you MUST unlock the cooktop before the gas surface burners will
operate.
11