Install single bypass valve, Installing holding clips, Install 3-valve bypass – Kenmore 625.38376 User Manual
Page 12: Installing 3 valve bypass and pipes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Install Single Bypass Valve
INSTALLING HOLDING CLIPS
Install 3-Valve Bypass
INSTALLING 3 VALVE BYPASS AND PIPES
Complete the following steps to install the three (3)
valve bypass:
• Cut the house main water pipe where you will con
nect the softener.
• Loosely put together pipe, fittings, and the three
(3) valves.
• Place valve(s) within easy reach.
When all pipe, fittings and valves make a good fit
together, tighten all threaded joints (use pipe dope
on outside threads), or solder all sweat joints.
Questions? Call The Kenmore Water Line 1-800-426-9345
12
Advertising