D. connect valve and salt tank drains, Step by step guides to install – Kenmore 180 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3
STEP BY STEP GUIDES TO INSTALL
D. CONNECT VALVE AND SALT TANK DRAINS
CONNECT SALT TANK OVERFLOW TU
BING
Take the rubber grommet, tube adaptor and
tube clamp (FIG. 12) that are on the small parts
cardboard liner.
Push the grommet into the hole in the salt tank
wall so half is inside and half is outside.
Push the bigger end of the tube adaptor into the
grommet.
tip Push one end of a length of 3/8" I.D. tubing onto
the tube adaptor, using the tube clamp to hold
it in place. Put the other end of the tubing over
the floor drain.
Important:
• The salt tank overflow is for safety only. If the
salt tank should overfill with water, the over
flow tubing carries it to the drain.
•
Over-fill water must run downward through
the tubing. Do not raise the tubing higher than
the grommet and tube adaptor (FIG. 12).
•
Do not connect to the valve drain hose you
installed in step 1. Both drains must have a sepa
rate hose or tube.
3 - 6
Deluxe Valve