B. unpacking the water softener, B. unpacking the water softener -2, Before installing checks & tests – Kenmore 180 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 1
BEFORE INSTALLING CHECKS & TESTS
B. UNPACKING THE WATER SOFTENER
Directions for unpacking the softener are on the top
of the shipping carton. This manual, and the own
er's manual, were on the small parts cardboard
packing piece. You will need the small parts to
install the softener. So you don't lose any parts, keep
them on the cardboard piece until you are ready to
use them. Remove all other cardboard pieces, foam
packings, tapes, etc. from the softener and discard.
Check the softener for shipping damage. If you
find damage, report it to your Sears store.
Use care when handling the softener. DO NOT turn
upside-down. DO NOT drop, or set on sharp objects
that could make a hole in the bottom. The water soft
ener is heavy and to avoid damage, or personal inju
ry, do not try to lift it or move more than necessary.
See page 3-4, when you are ready to move it into
installation position.
FIG. 1
FARTS DESCRIPTIONS
SMALL PARTS
SALT HOLE
NOZZLE
ASSEMBLY
VALVE
ASSEMBLY
bypass valve
(included with some models)
r
' installation manual
r^ner’s manual I
L
J
J
ground clamp kit
Wj
drain elbow
tube
adaptor
grommet tube
^ clamp
1
-
2
Deluxe Valve