Install single bypass valve, Fig. 10, Installing holding clips – Kenmore 625.38356 User Manual
Page 12: Bypass valve turned downward, Fig. 12, Install 3-valve bypass, Installing 3 valve bypass and pipes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install Single Bypass Valve
iMr
Hr ■
Before installing the bypass valve, or
copper tube, be sure the turbine and
support are firmly in place in the
valve outlet port.
Turbine
Support
II
Sensor Port
/
\
Turbine
FIG. 10
INSTALLING HOLDING CLIPS
BYPASS VALVE TURNED DOWNWARD
Turn bypass valve upside
down to connect to floor
level plumbing.
FIG. 12
Install 3-Valve Bypass
INSTALLING 3 VALVE BYPASS AND PIPES
Complete the following steps to install the three (3)
valve bypass:
• Cut the house main water pipe where you will con
nect the softener.
• Loosely put together pipe, fittings, and the three
(3) valves.
• Place valve(s) within easy reach.
When all pipe, fittings and valves make a good fit
together, tighten all threaded joints (use pipe dope
on outside threads), or solder all sweat joints.
Questions? Call The Kenmore Water Line 1-800-426-9345
12