Connecting the projector to a desktop computer – Compaq MP2800 User Manual
Page 10
Getting Started
10
Part Number: 216023-001 - Writer: Carey Gregg - Saved by: The Integrity Group
Pages: 18 Words: 2766 Saved date: 09/22/0010:37 AM File Name: Ch01.doc
Connecting the Projector to a Desktop Computer
1. Rotate the elevator foot to balance the projector.
2. Connect one end of the projector signal cable
➊B to the projector and
the other end to the VGA connector on the desktop computer and
tighten the screws.
✎
If your computer has a digital connector, connect one end of
the DVI signal cable
➊A to the digital connector on the
projector and the other end to the digital connector on the
computer.
✎
Be sure the signal cable aligns with the connector. Do not force
the cable onto the connector or you may damage the signal
cable or the projector.
3. Connect one end of the power cord
➋ into the back of the
projector, and the other end to an electrical outlet that is easily
accessible and close to the projector. The projector will
automatically be placed into Standby mode.