Bosch L0609466 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
Install Strain Relief
Place strain relief in knockout below terminal block. See Figure 11: Strain Relief
Knockout,
jdk.
Warning:
The strain relief provided with your range cord must be properly
installed.
Strain reliefs vary. Carefully read and follow the instructions included
with your strain relief.
1, In the knockout panel below the terminal block, remove the knockout that fits
your strain relief.
2, Feed range cord through hole and strain relief up to terminal block. Allow for
slack in the cord between the strain relief and terminal block.
3, Once cord length/ slack has been adjusted, attach strain relief per instructions
included with strain relief.
Figure 11: Strain Relief Knockout
Tip:
The knockout panel below the terminal block can be removed from
the range to install the strain relief: Remove knockout panel from
range, install strain relief in panel and reattach, DO NOT remove
entire range back panel.
English 12