Bosch L0609466 - Manual (Page 20)

Installation
drawer
\
adjustable leg
Slide Range into Opening
Figure 21: Adjust the Front Leveling Leg
1. Plug in power cord.
2. Slide range into opening, being careful not to damage countertops, floors, or
the range drawer front. Do not apply pressure to cooktop when sliding into
position. Be careful not to crimp flexible connector.
Tip:
2
.
3.
If the range does not slide easily:
Use soapy water to dampen the following pressure points:
•
countertop
• foam tape
• floor under range legs
Remove drawer and oven door to prevent damage
To prevent damage to the appliance, push on the frame around
the oven cavity opening.
3. Wipe up soapy water.
Check Back of Range for Proper Installation
1, When properly installed, the cooktop trim around the back of the range will
rest lightly on the countertop.
Note:
When replacing a free-standing model, the backwall trim strip should
be flush with the wall.
2. There should not be any gap between the countertop and the trim; however,
the weight of the range must not rest on the countertop. Look under the range
to verify that both back legs are resting solidly on the floor. Also verify that the
left range leg is under the anti-tip bracket.
Caution:
Verify that the weight of the range is not resting on the countertop.
This could result in damage to the countertop and the appliance.
If the back legs are not resting solidly on the floor or the left leg is not under
the anti-tip bracket, slide range out, adjust legs and slide back in.
English 18