Bosch L0609466 - Manual (Page 22)

Installation
1, Make sure circuit breaker is off and then plug range cord into electrical outlet.
Caution:
Before you plug in an electrical cord, be sure all controls are in the
Off position.
2. Line up range in front of opening.
3. Measure back left corner of opening from floor to top of countertop.
4. Adjust front leveling legs so that the bottom of the cooktop trim is 14" higher
than the corresponding countertop surface.
drawer
wrench
\
adjustable leg
Figure 23: Adjust the Front Leveling Leg
5. Repeat in right back corner.
6. Adjust front leveling legs so that the bottom of the cooktop trim is 14" higher
than the corresponding countertop surface.
Slide Range into Opening
1. Plug in power cord.
2. Slide range into opening, being careful not to damage countertops, floors, or
the range drawer front. Do not apply pressure to cooktop when sliding into
position.
Tip:
1. If the range does not slide easily, use soapy water to dampen the
following pressure points:
• countertop
• foam tape
• floor under range legs
2. Remove drawer and oven door to prevent damage
Check Back of Range for Proper Installation
1. When properly installed, the cooktop trim around the back of the range will
rest lightly on the countertop.
Note:
When replacing a free-standing model, the backwall trim strip should
be flush with the wall.
2. There should not be any gap between the countertop and the trim; however,
the weight of the range must not rest on the countertop. Look under the range
English 20