Select the source for recording, Start recording – Kenwood MS-A5 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
m
* It is not possible to record to metal tapes on this unit (metal tapes may only be
played).
Preparations
(T) Insert a cassette tape,
(D Select reverse mode (either to record
-------
both sides once or to record one side
only).
(3) Select Dolby NR if desired,
(?)
Select
the
direction
of
tape
movement:
A
(forward)
or
B
(reverse).
□
—1
[HlEl
-------- i
= g| # j
Select the source for recording.
TAPE HJMEB CO
O Q ^
Main Unit
CD/TAPE TUNEB
Rernote
Control Unit
C. 1
Start recording.
© Start the source for recording.
©
Press the REC key.
• nEC II PAUSE
Main Unit ^
•
Control Unit
n
To pause recording.
• REC II PAUSE
Main Unit
II
Remote ^
Control Unit
O
To stop recording.
Main Unit
^
■
Remote
Control Unit
O
"TAPE" cannot be selected.
When "CD"has been selected, press either the "□"key or
">DD"
key in the CD section to stop (or pause) the CD if it is
playing.
• REC II PAUSE
•
Main Unit ^
Remote ^
Control Unit P
When the REC key is pressed during recording, the deck
enters the record-pause mode after creating a non-re-
corded blank of 4 seconds.
To restart recording, press the REC key again.
Beat cancel
When recording AM radio broadcasts, a high-pitched sound may be re
corded. This is caused by the interaction of the recording circuit and the
signal. This sound can be minimized by changing the circuit as follows:
(T) Tune in the AM broadcast and then set to recording pause mode.
(D Press the tuning UP and DOWN keys simultaneously, The circuit will be changed
each time the keys are pressed in this manner.
(D
(D