Kenwood MS-A5 User Manual

Page 32

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Center unit

3jE ; Amplifier section

I

Rated power output

.

- ^

For U.SA and Canada

10 watts per channel minimum RMS, both Channels
driven, at 6 Q from 60 Hz to 20,000 Hz with no more

than 5% total harmonic distortion fFTC)

For U.K. and Europe

{DIN) 1 kHz at 6 n.........................................10 W +10 W
ilEC11 kHz at 6
a.......................................... 10 W +10 W

For other countries

(EIAJ) 1 kHz at 6 a....................................... 12 W +12 W

Total harmonic distortion (1 kHz, 3.3 W, 6

...„0.1%

Frequency response ............................60 Hz to 20 kHz

Tuner section

FM Tuning frequency range.........88 MHz to 108.0 MHz
AM Tuning frequency range........................... See below.

CD player section

Laser .......... ....................
Frequency response....

Signal to noise ratio....

........Semiconductor laser
................. 60 Hz to 20 kHz
....... . higher than 80 dB

Frequency response

Normal............... .............. .................. 50 Hz to 14 kHz
CrOz tape............................................. . 50 Hz to 15 kHz

Signal to noise ratio (DOLBY NR ON)............... ......56 dB
Wow «[flutter...................................... ...0.15% (W.R.M.S)

General

Power consumption ................................................. 35 W
Dimensions................ 175(W)

X

204(H)

X

225(D) mm

Weight.............................................................................. 3.3 kg

Speakers

Type.............................. 2-Way system, bass-reflex type
Rated impedance....................... ................................... 6 O
Maximum input level.................................................. 15 W
Output sound pressure .............................88
dB/W/m
Frequency response......................... ......80 Hz to 20 kHz
Dimensions................ 126(W)

x

204(H)

X

195(D) mm

Weight....................................................................... 1.6 kg

Wow 8i flutter .................. under the measurable limit

Cassette deck section

Type ..........................

4 track 2 channel

Recording system...........AC bias (Frequency; 105 kHz)
Heads Playback/recording head............... .

1

Erasing head ................. . 1

AM tuning frequency range

U.S.A,

530 kHz to 1710 kHz

CANADA

530 kHz to 1710 kHz

AUSTRALIA

531 kHz to 1602 kHz

EUROPE

531 kHz to 1602 kHz

U.K.

531 kHz to 1602 kHz

OTHER COUNTRIES

530 kHz to 1610 kHz (10 kHz STEP Area)

531 kHz to 1602 kHz (9 kHz STEP Area]

KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without
notice.

FortheU.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy, Changes or modifications to this equipment may cause harmful interfer­
ence unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
NOTE:

This equipment has been tested and found to comply with the limits for a.Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful inleiference in a residential installation. This equipment may
cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can "be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.

- - Reorient or relocate the receiving antenna.
- - Increase the separation between the equipment and receiver.
-

Connect the equipment into an outlet on a eircuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Advertising