Troubleshooting guide, Bl the sirius mode cannot be selected, 10 i – Kenwood KCA-SR50 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting Guide
If you use this for the first time, it may be
difficult to receive signals in the beginning.
In such a case, leave the SIRIUS source ON
for 3 minutes and turn it OFF and ON.
What might appear to be a malfunction in
your unit may just be the result of slight
misoperation or miswiring. Before calling
service, first check the following table for
possible problems.
Bl The SIRIUS mode cannot be selected.
✓ The SIRIUS connection wire is not connected.
^
Use the SIRIUS connection wire to connect the
............ control unit and the SIRIUS satellite radio tuner.
✓ The changer switching unit "KCA-S220A" is not
connected properly.
Connect the KCA-SR50 to the terminal labelled
TO CHANGER 2. See the section on <Connecting
Wires to Terminals>.
B Nothing happens when the buttons are pressed.
✓ The computer chip in the unit is not functioning
normally.
Press the reset button on the Control unit.
B No broadcast can be received.
✓ No subscription is established.
13“ Subscribe to SIRIUS.
The following messages are displayed
when certain problems are occurring
in your system. Take the recommended
actions.
ANTENNA ERROR / ANT ERR / ANT ERROR :
Antenna is not connected correctly.
O Make sure the antenna is connected
correctly and then turn OFF/ON of the
SIRIUS source or Control unit.
TUNER ERROR/TUNE ERR:
Broadcast cannot be received due to an error
in this unit.
Turn OFF/ON of the SIRIUS source or
Control unit, or press the reset button of
Control unit.
ESN ERROR/ESN ERR :
ESN (Electronic Serial Number) is not
registered in this unit.
O Consult your nearest service center.
CHECK SIRIUS/CHKSSR :
The SIRIUS tuner is disconnected or a unit
other than the SIRIUS tuner is connected.
C Check the connection to the SIRIUS tuner.
10 I
English