Kenwood KCA-SR50 - Manual (Page 6)

Operations
Channel Scan
Every receivable channel is checked for 10 seconds.
1 Start Channel Scan
Press the [AUTO] button for at least 2 seconds.
The channel scan will start.
2 Release it when the channel you want to listen
to is received
Press the [AUTO] button for at least 2 seconds.
Switching Seek Mode
Sets the seeking mode.
Press the [AUTO] button.
Each time the button is pressed, the Seek mode
switches as shown below.
Display Opeiiilaii ^ ^ ^ ^ ^ ^ ^
"Channel'V'CHANNEL" Normal manual seeking control.
"Preset’TPRESET" Search In order of the channels in the
Preset memory.
This function cannot be used in the category and
channel search mode.
Category and Channel Search_________
Select the category and channel you wish to listen
to.
1 Enter category and channel search mode
Press the [►!!] button.
2 Select the category
El Push the Control knob towards up or down.
□ Press the [FM] or [AM] button.
3 Select the channel
Qj Push the Control knob towards right or left,
ig Press the [!◄◄] or [►►)] button.
Canceling category and channel search mode
Press the [►!!] button.
You cannot operate this unit until all the Category
information is acquired.
Switching Display
When you are listening to the Sirius satellite radio,
you can switch over the display information as
follows.
For operations, see the <Swltchmg Display>
page of the instruction manual of your control
unit.
• What is displayed may partly depend on control units to
be connected.
InformaMoB _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ __ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Channel Name
Song Title
Artist Name
Composer name
Category Name
Band & Channel Number
If the text, including Channel name, etc. is selected
when the channel which does not have text, including
Channel name, etc. is played, band & channel number is
displayed.
Function of remote control
Direct Access Tuning
Entering the channel and tuning.
1 Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
2 Enter the channel
Press the number buttons.
3 Do Channel Search
Press the [!◄◄] or [►►!] button.
Canceling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
If you cannot receive any signal in the input channel due
to a bad condition on radio wave or another problem,
'Acquiring Signal"/ "ACQUIRING SIGNAL" appears.
English